I'm working on some tapered sliding dovetails for a case piece. My router "table" setup (shown upside down here) for routing the male part is pretty basic - just a piece of mdf with attached router base. The fence is the best part of the whole setup - flat, square, rigid. But, I'm showing this because I have found (the hard way, of course) that it's good practice to keep a setup intact until you absolutely need to dismantle it to do something else. That way if you realize you forgot to run one piece, just go back to the setup and run it. So this will sit here on my outfeed until all the dovetails are fit.